Known as: support

View/Change Diagram

911 1989-94 - Engine

Complete carburetion kits !

Complete kits include pre-jetted and sized carburetors, manifolds, linkage, K&N watershield air cleaners, pressure control unit, heat insulator kit, oil tank breather, fuel line & filter, clamps, injector plugs (as needed), power brake check valve (as needed) and complete installation instructions.

The pmo carburetor was designed from the beginning to be a state-of-the art carburetor. Pmo start off with a casting designed around a 50mm throttle plate and downsized to 46 and 40mm to achieve three different sizes. This compares favorably with conventional carburetors, including weber.
The air entry and flow is much greater than the weber. This is accomplished by having larger ma...(choose a part on the right to read more)

General Fitment

This is a true, 935-style spring plate design for the c2/4. Under hard cornering, rubber mounted suspension points can deform effecting critical angles of camber and toe. Erp/weltmeisters spring plates incorporated heim-joint linkage for precise suspension movement, a necessity for high speed handling and stability. The plates have also been designed to be mounted either right-side up or upside-down, offering a larger number of alignment settings.

* recommended for use with bearing kit r910593 (front) or r910592 (rear)

General Fitment

This replica high butterfly mfi throttle bodies system is for those looking for ultimate engine performance as well as an authentic rsr engine appearance. This kit keeps air consistently on tap for superior drivability. When the throttle is opened, there is an instant injection of air, providing a sharp, crisp throttle response. This efficient injection frees up more power and compliments larger displacements, high lift cams and full exhaust systems. This kit is engineered, precision machined, flow tested and manufactured in Germany. It is replicated to look as close to the original as possible. Intake trumpets (velocity stacks) are available in your choice of red or black. Includes: 6 individual stacks (48 mm ...(choose a part on the right to read more)

Panamera models with optional air suspension utilize four sensors to control the ride height. This is accomplished via the use of a small linkage or link which connects the sensor to the suspension. As the car is raised or lowered, the link moves the sensor up or down sending a signal to the computer telling it how high the car is. When you replace the non-adjustable factory link with this adjustable design, the output of the sensor makes the computer believe that the car is higher than it is. So, the computer will lower the ride height. The simplicity of this setup is that it retains full functionality of the factory system. Be warned, all adjustable lowering links are not the same! These links are machined al...(choose a part on the right to read more)

Ball pin to repair bell cranks, crossbars or any linkage part that takes an 8 mm ball pin. Made with a 5 mm threaded shank for easy installation.